Canon DP-V3010 - Manual (Page 39)

39 OSD Menu
Channel Settings
This is the menu to use for input signal related settings. Select the "Select Channel" and choose a channel number
from CH1 to CH30. Finally define the parameter of each of the "Channel Settings".
Item Setting Options (underline indicates factory default)
Select Channel Display the channel number. In addition, you can assign each content of "Channel Settings" to each
channel (
40).
CH1 to CH30
Note
• It may take 10 seconds when switching channels.
Input Configuration Select the input. Factory default depend on the channel ( 40).
3G-SDI 1, 3G-SDI 2, Dual Link HD-SDI, HD-SDI 1, HD-SDI-2, DisplayPort, — (Not set)
Select Input Signal Sets the signal display method ( 16).
4K Input: Displays the signal transmitted over four inputs.
Single Input: Displays the signal of a single input onto the center of the screen. Select from A to D.
Format Sets the color format and gradation.
Automatic, 4:2:2 YCbCr 10-bit, 4:2:2 YCbCr 12-bit, 4:4:4 RGB 10-bit, 4:4:4 RGB 12-bit,
4:4:4 XYZ 12-bit
Note
• HD-SDI is fixed to "4:2:2 YCbCr 10-bit".
• DisplayPort is fixed to "Automatic".
• If set to "Automatic" when receiving 3G-SDI or Dual Link HD-SDI input, all four signals without
a payload format will be rendered in "4:4:4 RGB 10-bit". In addition, if there is one Payload or
more of the four inputs, they are rendered in a Payload that is selected in the order of priority
A → B → C → D in the display area.
COP
Y