Aiwa XD-DV520 - Manual (Page 7)

ENGLISH
7
INTRODUCTION
En
Before using the remote control
A battery (CR2025) is already installed in the remote control
when shipped from the factory
.
Remove the insulating tape from the battery holder by
pulling its end as shown below
.
When to replace the battery
The maximum operating distance between the remote
control and the remote sensor of the unit is approximately
7 meters. If the operating range decreases, replace the
battery with a new one.
How to replace the battery
Insert a ballpoint pen or similar pointed tool in the notch of
the battery holder at the bottom, and then slide out the
battery holder . Place a new battery (CR2025) into the
battery holder with correct polarity
. Finally , push the holder
back into position.
NOTES
• When operating with the remote control, point the top of
the remote control toward the DVD player .
• If the unit is not going to be used for an extended period
of time, remove the battery to prevent possible electrolyte
leakage.
• The remote control may not operate correctly when:
- There is an intense light, such as sunlight, in the line
of sight between the remote control and the DVD player .
- There is fluorescent lighting near the remote sensor .
- Other remote controls are used nearby (those of a TV
set, etc.).
REMOTE CONTROL
CAUTION
• Lithium battery (CR2025) for the remote control
Replace the battery with Hitachi Maxell or Panasonic,
Part No. CR2025 only . Use of another battery may
present a risk of fire or explosion.
The battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
• Do not keep metallic objects such as rings, bracelets,
and keys near the battery . They may cause the battery
to short circuit.
• After removing the battery , be sure to keep it out of
reach of children. If it is swallowed, consult a doctor
immediately .