Brother PT-2100 - Manual (Page 48)

EDITING A LABEL
46
Creating a Barcode Label
z
Barcode Settings
z
Entering Barcode Data
Press the key to display the Setup menu, select
"Barcode Input" using the or key, and then
press the
or key.
The Barcode Input screen is displayed.
Type in the barcode data.
Special characters can be entered in the barcode when
using the CODE39, CODABAR, CODE128 or EAN128
protocols. When not using special characters, go to
step 5.
Press the key.
A list of characters available for the current protocol is
displayed.
Select a character using the or key, then press
the or key to insert the character in the barcode
data.
Attribute Value
Protocol
CODE39, CODE128, EAN8, EAN13, EAN128,
UPC-A, UPC-E, I-2/5, CODABAR
Width
Large
Small
Under#
(characters printed
below barcode)
On
Off
C.Digit
(check digit)
Off
On
(only available for the CODE39, I-2/5
and CODABAR protocols)
• Up to five barcodes can be entered in a label.
• Pressing
key while holding down key
will also allow you to go to "Barcode Input".
1
2
3
4