Brother HL-2170W User Manual

Page 63

Wireless configuration for Macintosh

using the Brother installer application (For HL-2170W)

Confirm the on-screen message and click Next.

Press the wireless setup button located at the back of the machine for less than 2 seconds as show in
the illustration below. This will put the printer in one-push wireless setting mode. This feature will
automatically detect which mode your access point uses for one-push configuration
(SecureEasySetup™, Wi-Fi Protected Setup™ or AOSS™) of your printer.

Note

• Use a pointy object such as a ballpoint pen to press the button.
• If you press the button for 3 seconds or more, the printer will change to the PIN Method of the

Wi-Fi Protected Setup™ mode. See How to configure your wireless printer, using the PIN Method of Wi-Fi
Protected Setup™ on page 80.

The printer starts the one-push wireless setting mode.
The printer searches for an access point that supports SecureEasySetup™, Wi-Fi Protected Setup™ or
AOSS™ for 2 minutes.

Put your access point in the SecureEasySetup™ mode, the Wi-Fi Protected Setup™ mode or the
AOSS™ mode, depending on what is supported by your access point. Please refer to the instruction
manual that came with your access point.