Brother DCP-J152W - Manual (Page 46)

34
e
Each color has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
f
Gently push the back of the ink cartridge
—marked PUSH— until it latches, and
then close the ink cartridge cover.
g
The machine will automatically reset the
ink dot counter.
NOTE
• If you replaced an ink cartridge, for
example Black, the LCD may ask you to
verify that it was a brand new one (for
example, Did You Change
Black).
For each new cartridge you installed,
press + (Yes) to reset the ink dot counter
for that color. If the ink cartridge you
installed is not a brand new one, be sure
to press - (No).
• If the LCD displays No Ink Cartridge
or Cannot Detect after you install the
ink cartridge, check that the ink cartridge
is installed correctly. Remove the ink
cartridge and reinstall it slowly and firmly
until it latches.
IMPORTANT
• DO NOT take out ink cartridges if you do
not need to replace them. If you do so, it
may reduce the ink quantity and the
machine will not know the quantity of ink
left in the cartridge.
• DO NOT touch the cartridge insertion
slots. If you do so, the ink may stain your
skin.
• If you mix the colors by installing an ink
cartridge in the wrong position, the LCD
displays Wrong Ink Color. Check
which ink cartridges are not matched by
color to their ink cartridge positions and
move them to their correct positions.
• Once you open an ink cartridge, install it in
the machine and use it up within six
months of installation. Use unopened ink
cartridges by the expiration date written on
the cartridge package.
• DO NOT dismantle or tamper with the ink
cartridge; this can cause the ink to leak out
of the cartridge.