Brother MFC-J270W - Manual (Page 66)

52
d
Turn the green knob on the protective
yellow cap clockwise until it clicks to
release the vacuum seal, then remove
the cap (1).
e
Each color has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
f
Gently push in the ink cartridge until it
clicks, and then close the ink cartridge
cover.
g
The machine will automatically reset the
ink dot counter.
Note
• If you replaced an ink cartridge, for
example Black, the LCD may ask you to
verify that it was a brand new one (for
example, Did You Change
Black).
For each new cartridge you installed,
press 1 (Yes) to automatically reset the
ink dot counter for that color. If the ink
cartridge you installed is not a brand new
one, be sure to press 2 (No).
• If the LCD shows No Ink Cartridge or
Cannot Detect after you install the ink
cartridges, check that the ink cartridges
are installed properly.
CAUTION
If ink gets in your eyes, wash it out with
water at once and call a doctor if you are
concerned.
1