Brother DCP-585CW - Manual (Page 63)

PhotoCapture Center
®
: Printing photos from a memory card or USB Flash memory drive
51
5
How to set new default
5
You can set your own default settings.
a
Press (Scan).
b
Press a or b to choose
Scan to Media.
Press OK.
c
Press a or b to choose
Set New Default.
Press OK.
d
Press + to choose Yes.
e
Press Stop/Exit.
How to reset to the factory
settings
5
You can restore all the settings you have
changed to the factory settings.
a
Press (Scan).
b
Press a or b to choose
Scan to Media.
Press OK.
c
Press a or b to choose
Factory Reset.
Press OK.
d
Press + to choose Yes.
e
Press Stop/Exit.
Understanding the
Error Messages
5
Once you are familiar with the types of errors
that can occur while you are using
PhotoCapture Center
®
, you can easily
identify and troubleshoot any problems.
„ Hub is Unusable.
This message will appear if a Hub or USB
Flash memory drive with a Hub has been
put into the USB direct interface.
„ Media Error
This message will appear if you put in a
memory card that is either bad or not
formatted, or when there is a problem with
the media drive. To clear this error, take
out the memory card.
„ No File
This message will appear if you try to
access a memory card or USB Flash
memory drive in the drive (slot) that does
not contain a .JPG file.
„ Out of Memory
This message will appear if you are
working with images that are too large for
the machine's memory. This message will
also appear when a memory card or USB
Flash memory drive you are using does
not have enough space available for the
scanned document.
„ Media is Full.
This message will appear if you are trying
to save more than 999 files in a memory
card or USB Flash memory drive.
„ Unusable Device
This message will appear if a USB device
or USB Flash memory drive that is not
supported has been connected to the USB
direct interface. (For more information,
visit us at http://solutions.brother.com.)
This message can also appear if you
connect a broken device to the USB direct
interface.