Brother HL-8050N - Manual (Page 14)

XIII
Internal laser radiation
Max. Radiation Power 5 mW
Wave Length 770 nm-800 nm
Laser Class Class IIIb (Accordance with 21 CFR Part 1040.10)
Safety Information
IMPORTANT - For Your Safety
To ensure safe operation the three-pin plug supplied must be inserted only into a standard three-pin power
outlet/socket which is properly grounded/earthed through the normal standard wiring.
Extension cords should not be used with the equipment. If it is essential that an extension cord has to be used, it
must be a three-pin plug type and correctly wired to provide proper grounding/earthing. Incorrectly wired extension
cords may cause personal injury and equipment damage.
The fact that the equipment operates satisfactorily does not imply that the power is grounded/earthed and that the
installation is completely safe. For your safety, if in any doubt about the effective grounding/earthing of the power,
call a qualified electrician.
This product should be connected to an AC power source within the range indicated on the rating label. DO NOT
connect it to a DC power source. If you are not sure, contact a qualified electrician.
Disconnect device
This printer must be installed near an AC power outlet/socket that is easily accessible. In case of emergencies, you
must disconnect the power cord from the power outlet/socket to shut off the power completely.
Caution for batteries
Do not replace the battery. There is a danger of explosion if the battery is incorrectly replaced. Do not disassemble,
recharge or dispose of in a fire. Used batteries should be disposed of according to local regulations.
Opmerking / Oplaadbare Batterij Recycle Informatie (For Netherlands Only)
Bij dit product zijn batterijen geleverd. Wanneer deze leeg zijn, moet u ze niet weggooien maar
inleveren als Klein Chemisch Afval.
Radio Interference (220 - 240 V Model Only)
This printer complies with EN55022 (CISPR Publication 22)/Class B.
IT power system (For Norway Only)
This product is also designed for IT power system with Phase to phase voltage 230V.
LAN Connection
Caution: Connect this production to a LAN connection which is not subjected to over-voltages.