Brother HL-8050N - Manual (Page 103)

4 - 23 CONTROL PANEL
List of factory settings
The following table shows the factory settings. To reset the printer’s network settings, see Network
Factory Default Setting on page 3-18.
■
The emulation mode affects the setting. Effective modes are shown in brackets in the following
table.
■
The following settings can not be restored to the factory settings with the reset menu in the
factory settings mode interface mode, HRC setting, page protection, scalable font, lock panel,
page counter and local language for display messages.
■
The copy setting is always restored to the factory setting when the printer is turned off and on
again.
Menu Factory Setting
PAPER SOURCE AUTO
PRIORITY T1>T2>T3>T4
MANUAL FEED OFF
TRAY1 SIZE DETECT SENSOR
TRAY2 SIZE DETECT SENSOR
TRAY3 SIZE DETECT SENSOR
TRAY4 SIZE DETECT SENSOR
DUPLEX OFF
OUTPUT STANDARD
JOB OFFSET ON
QUALITY RESOLUTION 600
HRC MEDIUM
TONER SAVE OFF
DENSITY 0
SETUP LANGUAGE ENGLISH
PANEL CONTROL LOWER LCD NONE
AUTO ONLINE ON
BUTTON REPEAT 0.1 SEC
MESSAGE SCROLL LEVEL 1
POWER SAVE TIME 30MIN
AUTO CONTINUE OFF
TONER LOW CONTINUE