Brother MFC-685CW - Manual (Page 94)

Control panel setup
86
6
Gateway
6
This field displays the current gateway or router address used by the machine. If you are not using DHCP or
BOOTP to obtain the gateway or router address, enter the address you wish to assign. If you do not have a
gateway or router, leave this field blank. Check with your network administrator if you are unsure.
a Press Menu.
b Press a or b to select LAN.
Press OK.
c (For Wired) Press a or b to select Wired LAN.
(For Wireless) Press a or b to select WLAN.
Press OK.
d
Press a or b to select TCP/IP.
Press OK.
e
Press a or b to select Gateway.
Press OK.
f Enter the Gateway address.
Press OK.
Note
For DCP models, press a or b repeatedly to enter the first three-digit number for the Gateway address.
Press c to enter the second three-digit number. Repeat this step until you have entered the fourth three-
digit number to complete the Gateway address. Press OK.
g Press Stop/Exit.
Node Name
6
You can register the machine name on the Network. This name is often referred to as a NetBIOS name; it will
be the name that is registered by the WINS server on your network. Brother recommends the name
BRNxxxxxxxxxxxx for a wired network or BRWxxxxxxxxxxxx for a wireless network (where xxxxxxxxxxxx is
your machine’s Ethernet address) (up to 15 characters).
a Press Menu.
b Press a or b to select LAN.
Press OK.
c (For Wired) Press a or b to select Wired LAN.
(For Wireless) Press a or b to select WLAN.
Press OK.
d Press a or b to select TCP/IP.
Press OK.
e
Press a or b to select Node Name.
Press OK.