Brother MFC 8220 - Manual (Page 188)

9 - 7 NETWORK SCANNING
Scan to Image
When you select Scan to Image your original document will be
scanned and sent directly to the PC you designated on your network.
The Brother SmartUI will activate the default graphics application on
the designated PC. You can change the Scan configuration. (For
Windows
®
98/Me/2000: See Scan to Image on page 4-16 to 4-17.)
(For Windows ® XP: See Hardware Section: Changing the Scan to
button configuration on page 5-5 to 5-11.)
1
Place the original document face down in the ADF.
2
Press ( Scan ).
3
Press or to select Scan
to Image .
Press Set .
4
Press or to select a destination you want to send.
Press Set .
If the LCD prompts you to enter a PIN Number, enter the 4-digit
PIN Number for the destination PC on the control panel.
Press Set .
The MFC will start the scanning process.
For Network Scanning the Brother Control Center (SmartUI)
selections are used only for configuring the Scan button. You
will not be able to initiate a network scan from the Brother
Control Center (SmartUI).
Select ▲▼ & Set
Scan to Image