Brother MFC 8840D - Manual (Page 95)

10 - 6 FRONT PANEL SETUP MENU
Gateway
This field displays the current gateway or router address used by the
DCP/MFC. If you are not using DHCP or BOOTP to obtain the
gateway or router address, enter the address you wish to assign. If
you do not have a gateway or router, leave this field blank. Check
with your network manager if you are unsure.
1 (For MFC) Press Menu , 6 , 1 , 4 .
(For DCP) Press Menu , 4 , 1 , 4 .
2 Select 1 to change. Enter the Gateway address.
3 Press Set .
4 Press Stop/Exit .
Host Name
You can register the machine name on the Network. This name is
often referred to as a NetBIOS name; it will be the name that is
registered by the WINS server on your network. Brother
recommends the name BRN_XXXXXX (where XXXXXX is the last
six digits of the Ethernet address) (up to 15 characters).
1 (For MFC) Press Menu , 6 , 1 , 5 .
(For DCP) Press Menu , 4 , 1 , 5 .
2 Select 1 to change. Enter the Host Name.
3 Press Set .
4 Press Stop/Exit .