Avaya TransTalk MDW 9040 - Manual (Page 71)

Setting or Changing Handset Settings Programming & Using the MDW 9040 Pocket Phone
5
MDW 9040 Wireless Pocket Phone Installation and Use, 503-801-190 Issue 2, February 2001 63
8 To determine voice quality of both the handset and the radio module,
press the Softkey (
) below Man or Auto.
The display shows the voice quality (VOICE) for both the handset (H) and the
base (B) (the Dual Radio Module) using a number from 1 to 10, as shown in the
following table.
The higher the number, the better the voice quality, as shown in the following table. A
low number may indicate potential interfering devices (such as another radio
transmitter) in the area.
9 To determine the power level, press the Softkey ( ) below Man or Auto.
The display shows the power level (POWER) to which the handset (H) and the
base (B) (the Dual Radio Module) have adjusted. The power level adjusts from
low power (1) to high power (8) as the Pocket Phone is moved farther from its
radio module.
When the signal strength, voice quality, and power level tests are complete, the
following message appears on the display screen.
Figure 23. The Wireless Test Mode Screen with Test Results
Note: If you wish to view the test results another time and thus repeat the
Wireless Test, press the Softkey (
) below Man or Auto.
10 To exit both Wireless Test Mode and Menu Mode, press or .
Display Number Voice Quality Is
10 Very Good
9 Very Good/almost error free
8 Errors, but not noticeable in normal speech
7 Errors, but not noticeable in normal speech
6 Noticeable noise
5 Noticeable noise
4 Noisy but intelligible speech
3 Noisy but intelligible speech
2 Garbled speech
1 Unintelligible speech
SIGNAL:
VOICE:
POWER:
Man Back
H=uu
H=ww
H=yy B=vv
B=xx
B=zz
Auto
Menu