Brother QL-1060N - Manual (Page 10)

STEP1 Getting started 8
„ Front „ Rear
1
Press and hold the ON/OFF button to turn
the QL-1060N off. Pull up the left and right
levers on the machine under the top cover,
and open the cover.
2
Put the spool into the spool guides in the DK
Roll compartment.
•
Make sure that the spool arms are inserted firmly in
the spool guides on the left and right.
• Insert the spool with the DK Roll located on the right
hand side of the QL-1060N.
3
Thread the end of the DK Roll into
the slot until it aligns with the roller.
When unable to thread the end of the
DK Roll into the slot, thread it as far as
possible, and then close the cover.
Press the ON/OFF button to turn the
QL-1060N on, and then press the
FEED button to set the roll.
2 Parts Description
Main Printing Unit
FEED button
LED lamp
ON/OFF button
CUT button
DK Roll compartment cover
Power cord
USB port
LAN port
Serial port
3 Setting the DK Roll