Brother PT-9700PC - Manual (Page 47)

21
^RC Specify line feed command text string
[ASCII] ^ R C n1 n2 data
[Decimal] 94 82 67 nd1 nd2 datad
[Hexadecimal] 5E 52 43 nh1 nh2 datah
[Parameters] 0≤n1≤2
0≤n2≤9
00h≤datah≤FFh
[Description]
・ Specifies the text string for the line feed command.
(n1*10)+n2:
Length of the text string (can be set between 1 and 20)
data: Text string (The maximum number of characters that can be set is 20 characters
(bytes).)
・ The default text string for the line feed command is “^CR”.
・ This command is a dynamic command.
[Remarks]
・ Invalid if more than 20 characters are specified
[Example]
・ To change the text string for the line feed command to “0Dh 0Ah”:
Since the text string to be specified (data) contains 2 characters, n1=0 and n2=2. Therefore,
the command will be as follows.
^ R C 0 2 0Dh 0Ah
(5Eh 52h 43h 30h 32h 0Dh 0Ah)