Brother PT-9700PC - Manual (Page 36)

10
^PS Specify print start command text string
[ASCII] ^ P S n1 n2 data
[Decimal] 94 80 83 nd1 nd2 datad
[Hexadecimal] 5E 50 53 nh1 nh2 datah
[Parameters] 0≤n1≤2
0≤n2≤9
00h≤datah≤FFh
[Description]
・ Specifies the text string for the print start command.
(n1*10)+n2:
Length of the text string (can be set between 1 and 20)
data: Text string (The maximum number of characters that can be set is 20 characters
(bytes).)
・ The default text string for the print start command is “^FF”.
・ This command is a dynamic command.
[Remarks]
・ Invalid if more than 20 characters are specified
[Example]
・ To change the text string for the print start command to “START”:
Since the text string to be specified (data), “START”, contains 5 characters, n1=0 and n2=5.
Therefore, the command will be as follows.
^ P S 0 5 S T A R T
(5Eh 50h 53h 30h 35h 53h 54h 41h 52h 54h)