Brother PT-9700PC - Manual (Page 40)

14
^CF Full cut setting
[ASCII] ^ C F n1 n2
[Decimal] 94 67 70 nd1 nd2
[Hexadecimal] 5E 43 46 nh1 nh2
[Parameters] 0≤n1≤9
0≤n2≤9
[Description]
・ Specifies whether or not full cut is used, and specifies the number of copies.
(n1*10)+n2: Full cut and number of copies settings
(00: OFF; 01 to 99: Number of copies)
(Default value: 01)
・ This command is a dynamic command.
[Remarks]
・ The full cut label number setting can be between 1 and 99. This command becomes invalid
if any other value has been specified.
[Example]
・ To cut after every two labels:
Since the auto cut label number will be set to 2, n1=0 and n2=2. Therefore, the command
will be as follows.
^ C F 0 2
(5Eh 43h 46h 30h 32h)