Transmille 8000 Series - Manual (Page 21)

8000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Page 20
Preparing the Multimeter For Use
The multimeter front panel displays and function buttons will illuminate, with the function selected
remaining lit once the start up sequence is complete.
If the multimeter does not power up as expected check the following :
Check AC power is connected to the multimeter
Ensure AC power is supplied via the mains lead and the Off/ On switch is switch to the I (on)
position
Verify the line voltage selection on the rear power inlet is correct
Check voltage selector on the mains inlet
Check the line input fuse is OK and does not require replacement.
This can be performed using the continuity function on a basic hand held
multimeter.