TOHO ELECTRONICS TTM-P9 - Manual (Page 10)

9
⑥ Common parameter setting mode (The SET lamp lights.)
- This mode will set the parameter common to each pattern and step.
From reset mode
Hold the △ key and the PATT./STEP key down for 5 seconds
Set the PV correction zero point.
Set the PV correction gain.
Toggle between forward and reverse actions.
:Forward action (cooling) /: reverse action (heating)
↓
Press the PATT./STEP key.
Switch between sensor types.
: K thermocouple /: J thermocouple /: R thermocouple
Set the SV limiter upper limit.
Set the SV limiter lower limit.
Set the number of patterns.
Select PV or SV start.
: PV start /: SV start
Set a starting temperature for starting the SV.
(This will not be displayed at PV start.)
Set a proportional period.
Set a weight zone.
Set a wait time.
Select a time signal and an alarm output type.
For settings, see Table 1.
Alarm output sensitivity
(This will not be displayed when a time signal output is selected.)
PV 
SV 
[A]
PV 
SV 
PV 
SV 
PV  
SV 
PV 
SV 
PV 
SV 
PV 
SV 
PV 
SV 
PV 
SV 
PV  
SV 
PV  
SV 
PV  
SV 
PV 
SV 
PV 
SV 
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.
↓
Press the PATT./STEP key.