TOHO ELECTRONICS TTM000 - Manual (Page 19)

19
5.8 Setting a response delay
Set a time from the time when the high-level computer finished sending a "request message" until
the time when it delivers the line and enters an input state.
While in the "Set a response delay" on the preceding page, operate the ▲ and ▼ keys to make the
settings. The initial value is 0.
Setting range: 0 to 250msec
* If the response delay is set to a short setting, the communications may not be conducted normally.
* In a real operation, the processing time for this product will be added, in addition to the response
delay.
5.9 Switching communications mode
While in the "Set communication mode changeover" screen on page 17, operate the ▲ and ▼ keys
and make a setting.
Read/Write
Read-only
* The changeover setting is disabled.