Sterlco 2016C (Former Compact Series) - Manual (Page 43)

COT-C Series Hot Oil Portable Temperature Control Units Page 43
8. Pack ball bearing with Dow Corning #44 high temperature
silicon grease and install in the thrust bearing housing. Place
bearing spacer collars inside the lip seals. Thread the end cap
into the bearing housing and tighten with a spanner wrench.
Tighten the radial set screws that lock the end cap in place.
9. Using the snap ring pliers, install the snap ring onto the shaft.
10 Thread the thrust bearing assembly into the bracket. Turn until
hand tight. This forces the rotor against the head.
11. Put lock-washer and locknut on shaft. Insert length of
hardwood or brass through port opening between rotor teeth to
keep shaft from turning. Tighten locknut to 50 – 70 ft.-lbs.
torque and bend one tang of lock-washer into slot.
12. Adjust pump end clearance. Refer to section on Thrust Bearing
Adjustment.
13. Lubricate all grease fittings with Dow Corning #44 high
temperature silicon grease.