Setra System Model Datum 2000 - Manual (Page 10)

10
Step 5.
Press the HOLD/mode key to display the number “0”.
Note: The decimal point that was set during calibration (CAL_U, CAL_C) will
be displayed.
Step 6.
Set the value you wish the meter to display at the presently applied pressure.
Press the SCAN/adj key to move the numbers up (+).
Press the HOLD/mode key to move the numbers down (-).
When the desired number is reached, press the SCAN/adj and HOLD/mode
keys at the same time. The number will flash repeatedly. Then, press the
SCAN/adj key to readjust the number or the HOLD/mode key to accept it.
After the number is accepted, the meter will display “bUSY” for 10 seconds
and then resume normal operation.
SCAN HOLD
adj mode
OFF57
0.
SCAN HOLD
adj mode
25. 0.
SCAN HOLD
adj mode
–25. 0.