Kaman 8000 Enclosures - Manual (Page 19)

19
Input Voltage Selection (120VAC/240VAC)
Warning: When you change the input voltage on the rear panel
you must also change the MCD 8000 input voltage
or you may damage the unit.
Warning: The integral power supply in racks utilize high voltage
(120 or 240VAC). Unplug the unit before servicing.
To change the input voltage you must first select the proper input voltage on the power entry
module on the unit. To change the selected voltage:
a Open the cover using a small blade screwdriver or similar tool. Set aside
the cover/fuse block assembly and pull the voltage selector card straight
out of the housing. See fig. 9 on accessing the voltage selector card.
fig. 8 -- Power Entry Module;
fig. 9 -- Accessing the Voltage Selector Card;