Kaman KD-2300 User Manual
Kd-2300, Noncontacting displacement measuring system

Instruction Manual
KD-2300
Noncontacting Displacement Measuring System
EC DECLARATION OF CONFORMITY
This apparatus, when installed and operated per the manufacturer’s
recommendations, conforms with the protection requirements of EC Council
Directive 89/336/EEC on the approximation of the laws of the member states
relating to Electromagnetic Compatibility, as required by the Technical Construction
File Route to Conformity.
This certificate has been issued in accordance with the conditions of regulation No.
53 of U.K. Statutory Instruments 1992 No: 2372 – The Electromagnetic
Compatibility Regulations.
********
DO NOT MAKE ANY MODIFICATIONS TO CABLE LENGTH, SENSOR
OR CALIBRATED TARGET MATERIALS WITHOUT PRIOR
CONSULTATION WITH A KAMAN APPLICATION ENGINEER
*********
Copyright © 2000
PART NO: 860021
Rev. F
Document Outline
- EC DECLARATION OF CONFORMITY
- Introduction
- Customer Service Information
- Service Information
- Part I: What is the KD-2300?
- Part II: Getting Started
- Part III: The Equipment
- Inch (mm)
- Part IV: Calibration
- Appendix A: Glossary
- Appendix B: System Modifications
- Appendix C: Troubleshooting