Dwyer SCZ10 - Manual (Page 3)

3.1 Operation flow chart
PV/SV display mode
(Approx. 3s)
Control output MV indication
+ + (Approx. 3s) + (Approx. 3s)
[Main Menu] [Secondary Menu] [Auxiliary Menu] [Secure Menu]
mode 2 ]
Main setting
[ ] PID auto-tuning Perform/Cancel
[
]
Setting value lock selection
[ ]
Sensor selection
[
]
Proportional band setting
[ ] Sensor correction setting
[
]
Scaling high limit setting
[
]
Integral time setting
[ ] Instrument No. setting
[
]
Scaling low limit setting
[
]
Derivative time setting
[ ] Data transfer rate selection
[
]
Decimal point place selection
[
]
Anti-reset windup setting
[ ] PV filter time constant setting
[
]
Proportional cycle setting
[ ] Control output high limit setting
[
]
Manual reset setting
[
]
Control output low limit setting
[
]
Alarm setting
[
]
Control output ON/OFF action
hysteresis [
]
Heater burnout alarm setting
[ ] Alarm action selection
[
]
Loop break alarm time setting
[
]
Alarm action
Energized/Deenergized [
]
Loop break alarm action span
setting [
]
Alarm HOLD function selection
[
]
Alarm hysteresis setting
[
]
Alarm action delayed timer
setting [
]
Setting value digital transmission
bias setting [
]
Direct/Reverse action selection
[
]
Controller/Converter function
selection [
]
AT bias setting
[
]
• + : Press the key while the key is being pressed.
• + (Approx. 3 seconds): Press the key while the key is being pressed.
• + (Approx. 3 seconds): Press the key while the key is being pressed.
For setting and selecting in each setting mode, press or key.