Blue-White F-2000 – Solvent Weld PVC Tee Fitting - Manual (Page 5)

Terminal
Block
2 1
P2
P3 P1
A
-
V
+
3 position
jumper Pin Pin Header
(other side)
Terminal Number Terminal Block Connections
1
2
Positive (+) Analog Output Signal
Negative (-) Analog Output Signal
Terminal Configuration
Output Jumper Settings
4-20 Milliamp
0-10 Volts DC
Connect P1 & P2 (leave P3 open) (factory
default), Max Load = 250 Ohms
Connect P2 & P3 (leave P1 open), Max Load =
500 Ohms
P2
P3 P1
P2
P3 P1
Jumper Configuration
1.6 Model AO Circuit Board Wiring
CAUTION: DISCONNECT POWER SOURCE BEFORE SERVICING.
1.7 Model FHXX and FCXX Sensor wiring
RED Input Supply Voltage (+ 6 to 24 Vdc)
BARE Signal Output (square wave)
BLACK Ground (-)
RED Signal Output (Sine wave)
BLACK Ground (-)
Model FHXX
Model FCXX
Note: Output type - current sinking type hall effect sensor (13.5mA max).
Pull-up resistor is recommended. 5k ohm across red & bare wires.
F-2000 Page 5
Output Type: Linear, Non-Isolated, powered loop.
Loop resistance: 250 ohm maximum for 4-20mA output
500 ohm maximum for 0-10 V DC