Blue-White F-2000 – Solvent Weld PVC Tee Fitting - Manual (Page 16)

F-2000 Page 16
3.0 HOW TO OPERATE THE MODEL AO
3.1 What Was The MODEL AO Designed To Do?
3.3 How Do I Program The MODEL AO?
Note: The F-2000 must be powered by AC Adapter
! Output a 4-20mA or 0-10VDC signal which is proportional to the flow.
3.2 What Features Are Available?
! Front panel programmable zero and span.
! 20-4mA and 10-0VDC inverted logic capabilities.
! Front programming can be disabled for security.
! 4-20mA or 10VDC output signal (factory default) selected via jumper pin located on the circuit board.
Note: The output signal can be inverted. Either the low or the high output signal may be assigned to the lower or
Programming Screen Programming Screen Function
MA 2
MA 1
Input the desired flow rate which corresponds to an output signal of 4mA or 0VDC. This
value may be either the high or the low point in the range.
Input the desired flow rate which corresponds to an output signal of 20mA or 10VDC. This
is the opposite range point from the MA 1 setting (above).
Step 1 MA 1, Flow Rate at Low Output Signal (4mA or 0VDC).
Step 2 MA 2, Flow Rate at High output Signal (20mA or 10VDC).
! Press for at least 1.25 seconds to activate programming mode.
! Press to toggle through the different display screens until you reach the MA screen.
! Press to select the digit to be changed. Note: The selected digit will blink.
! Press to change the selected digit.
! Press .
! Press to select the digit to be changed.
! Press to change the selected digit.
! Press .
00000
MA
CLEAR
SETPOINT
ENTER
TOTAL
CLEAR
ENTER
ENTER
CLEAR
SETPOINT
TOTAL
CLEAR
ENTER
00000
MA
2