West Control Solutions KS 800 Profibus Interface Manual - Manual (Page 14)

Rem. E Unit_Contrl II
MSB LSB
D31 D30 D29 ... ... D2 D1 D0
Bit no. Name Allocation Status ‘0’ Status ‘1’
D0 OUT17 Forcing of output OUT17 off on
D1 OUT18 Forcing of output OUT18 off on
D2 OUT19 Forcing of output OUT19 off on
D3 OstartG Start optimizing all group controllers no start start
D4 OStopG Forcing of output OUT5 no stop stop
D5 Dval Forcing of output OUT6 flank 0->1
D6- D15 always "0"
Rem. F Cntrl_x
MSB LSB
D15 D14 D13 ... ... D2 D1 D0
Bit no. Name Allocation Status ‘0’ Status ‘1’
D0 A/M Automatic/manual switch-over auto manual
D1 Coff Controller switched off no yes
D2 w/W2 w/W2 switch-over w W2
D3 We/w External/internal switch-over external internal
D4 OStart Start optimization 1) no start start
D5 OStop Stop optimization 1) no stop stop
D6 .. D15 unused, always ‘0’
Rem. G Digital_Outputs
MSB LSB
D15 D14 D13 ... ... D2 D1 D0
Bit-No. Name Allocation Status ‘0’ Status ‘1’
D0 Y1_7 Y1-Output Channel 7 off on
D1 Y2_7 Y2-Output Channel s 7 off on
D2 Y1_6 Y1-Output Channel 6 off on
D3 Y2_6 Y2-Output Channel 6 off on
D4 Y1_5 Y1-Output Channel 5 off on
D5 Y2_5 Y2-Output Channel 5 off on
D6 Y1_4 Y1-Output Channel 4 off on
D7 Y2_4 Y2-Output Channel 4 off on
D8 Y1_3 Y1-Output Channel 3 off on
D9 Y2_3 Y2-Output Channel 3 off on
D10 Y1_2 Y1-Output Channel 2 off on
D11 Y2_2 Y2-Output Channel 2 off on
D12 Y1_1 Y1-Output Channel 1 off on
D13 Y2_1 Y2-Output Channel 1 off on
D14 Y1_0 Y1-Output Channel 0 off on
D15 Y2_0 Y2-Output Channel 0 off on
Process data
9499 040 50511 14
1) Signals are active only with change from 0 Ä 1. The signal must be available, until a change of Orun
(see Status_x) has occurred.
2)See chapter 3.3 page 15 "Disabling mechanism with changes".