SHIMPO FGS-100E - Manual (Page 11)

10
6.2. Speed unit change
① When changing the operation speed to inch/mm from mm/min
a) Power OFF
Turn ON the stand while holding down the “MAX” key.
Keep pressing the “MAX” key until the display shows JOG mode
b) After the stands turn ON, the display shows its model name
*Still keep pressing “MAX” key at this point
c) To JOg mode
Then, the stand goes to JOg mode.
The stand shows default value of operation speed.
Low speed ： ０．３０inch/min
High speed ： ０．８０inch/min
Then, the unit change is finished.
② When changing the operation speed to mm/min from inch/mm
a) Power OFF
Turn ON the stand while holding down the “MAX” key.
Keep pressing the “MAX” key until the display shows JOG mode
b) After the stands turn ON, the display shows its model name
*Still keep pressing “MAX” key at this point
c) To JOg mode
The stand goes to JOg mode and shows default of operation
speed.
Low speed ： ６mm/min
High speed ： ２０mm/min
The unit change is finished
FGS
OFF
Jog
FGS
OFF
Jog