SHIMPO DT-326 - Manual (Page 9)

6
3.3 LCD Display
3.3.1 Display Names and Descriptions
3.3.2 Main data display
- Internal flashing mode: Displays flash rate.
- External trigger mode: Display external trigger frequency.
-Display will indicate “P” or “LCD” (in ON/OFF setting of LCD backlight) in *Parameter setting mode.
*Parameter setting mode: Display LCD backlight setting (“P” or “LCD”)
3.3.3 Sub data display
Internal Flash Mode Display
-To change the degrees of phase shift, press PHASE + or PHASE - keys. The display will reflect the
cumulative angle of phase shift.
-“Flash Time” will be displayed when RATIO key is pressed. The flash time (pulse flash duration) can then
be set using the dial to increase or decrease the flash time from 0 to 2.5 (0 - 2.5°) degrees.
External Trigger Mode Display
-Displays delay time setting. Refer to section 4.4.2 for detail.
*Parameter Mode Display
- Displays the following:
-Selected measuring range
-Delay time (in ms)
-Backlit LCD (ON or OFF)
*Refer to 4.5 “Parameter setting mode” for detail.
3.3.4 Units of Measure: Display
Digital display will show the following according to the unit of measure setting.
Auto Range
Trigger
Divider
Edge Delay Deg
Flash Time
Mem
AveLast Min Max
Ave Last Min
min
sec
Hz
ms
○ ○ ○ ○
Battery indicator Main data display
Sub data
Setting project
Unit
Unit set to FPM
(flashes/minutes)
Unit set to Hz
min
Hz
min Min
Ｈｚ Ｈｚ Ｈｚ Ｈｚ
Flashing
(Blinking)