Revo RESPTZ37-1/HSC/HSW User Manual - Manual (Page 34)

REVO America www.revoamerica.com RESPTZ37-SERIES
32
INITIALIZE DATA
FACTORY DEFAULT
ERASE PROGRAMMED DATA
PRESET FOCUS DEFAULT
EXIT(ESC TO EXIT)
FACTORY DEFAULT Selection of Factory Default displays the following submenu.
FACTORY DEFAULT
ARE YOU SURE ?
CANCEL
OK
Selecting OK will restore the factory defaults and delete any changes that you have made.
ERASE PROGRAMMED DATA Selecting this submenu will enable you to choose which of the
data that has been stored on the camera’s Flash-ROM you wish to erase. You will be asked to
enter ON or OFF. If you desire to erase all data then select ERASE, otherwise press the ESC key
on the keyboard controller to exit without erasing. The erased data includes all stored data (Auto
Scan, Preset, and Tour….) except Origin Offset.
The Origin Offset value is still valid after all data is erased. See the Origin Offset section that
follows for more information.