Conductivity - setup menu - auto return 6.11 – Metex Shark Multi-Parameter Controllers & Analyzers User Manual

Page 90

Conductivity - Setup Menu - Auto Return 6.11

Page 88

MULTI-PARAMETER CONTROLLER & ANALYZER USER’S MANUAL

Conductivity - Setup Menu - Auto Return 6.11

DOWN

Not stored

DOWN

Stored

DOWN

Press the key to accept the change and
move to the RELAYS auto return function.
RELAYS ON will cause the relays to return to
the AUTO mode if the controller returns to
Online after 10 minutes of inactivity. This
ensures the controller will be put back in
control of the process if accidentally left offline.

NOTE

PRESS THE AND KEYS

TOGETHER TO GO IMMEDIATELY BACK TO

RUN MODE

DOWN

Then press the key to
store the selection and return
to the Auto Return Selection
Menu.

Press the key to
accept the change and move
to the STORE function

Use the or keys
to select either ON or OFF.

Press the key once
which will move the cursor to
the ON or OFF text

To change the MENU
RETURN setting,
Press the key once
which will move the cursor to
the ON or OFF text

MENU ON will cause the controller to exit the menu and
revert back to the online run mode after 10 minutes with no
buttons pressed. This feature ensures that if a user forgets
to return back to run mode, the controller will not be left in
an offline state. If for some reason, the user would like to
remain in the menu mode for extended periods of time, the
AUTO RETURN function can be set to "OFF".

AUTO RETURN is used to select what conditions will
cause the controller to time-out of the operations
menu, or reset the relay override function.

With "N" selected, pressing the
key will NOT store the selection, but
simply return to the AUTO RETURN
Selection Menu. This function is useful if
you wish to view the current selection
without making any changes.

CAUTION:

If AUTO RETURN RELAYS is ON, regardless of
the user settings of the states of the relays,
Relays will default to AUTO 10 minutes after the
Shark returns to Run Mode.

Or press the key to highlight

the Y character.

RUN MODE

Press the key
once which will move
the cursor back to the
RH side of the
display.

Use the or keys
to select either ON or OFF.

Press the key
once which will move
the cursor back to the
RH side of the display.

MENU O FF >

MENU O N >

STORE? Y N

AUTO RETURN

RELAYS ON >

RELAYS OFF

AUTO RETURN

RELAYS O N >

RELAYS O FF >

AUTO RETURN

UTILITIES

SETUP

1000uS 25.0C

CALIBRATION

TEMP SENSOR

TEMP UNIT

COND RANGE

AUTO RETURN
MENU ON

AUTO RETURN

MENU OFF >

AUTO RETURN