Martel Electronics BetaLOG-PI - Manual (Page 8)

not logging data, or to toggle between ON and STOP if logging
data.
• press the CONFIG key to step to the next menu item.
• press the ENTER key to exit configuration if the display is FULL,
ON, or OFF, to stop logging and exit configuration if the display
is STOP, or to start logging and exit configuration if the display is
START.
2) Display number of free log records
• Main display: number of free records
• Secondary display: FREE
• the ▼ and ▲ keys are ignored.
• press the CONFIG key to step to the next menu item if not
logging, otherwise it exits configuration.
• press the ENTER key to exit configuration.
3) Erase all logged data and set to Demand mode
• Main display: CLEAr
• Secondary display: DATA
• the ▼ and ▲ keys are ignored.
• press the ENTER key to step to the next menu item and confirm
erasure.
• press the CONFIG to exit configuration without erasing the data.
4) Confirm erasure of all logged data and set to Demand
mode
• Main display: CLEAr
• Secondary display: CNFRM
• the ▼ and ▲ keys are ignored.
• press the ENTER key to erase the data, set Demand mode, and
exit configuration after briefly displaying CLr to confirm erasure.
• press the CONFIG key to exit configuration without erasing the
data.
While not logging data, the gauge operates as described in the user
manual received with the gauge.
When a log run is started, the pressure unit and custom factor are
forced to the downloaded selections. They are restored to their
original values at the end of the run.
While logging data, the following operating changes occur:
• Pressing the power button causes the log run to be stopped
before power is turned off.
6