Martel Electronics BetaLOG-PI - Manual (Page 12)

4.1 Installation and Registration
Insert the distribution CD into the drive on your computer. The install
should start automatically. If it does not, navigate to the drive
containing the CD and run the program "setup.exe". Follow the
prompts on the screen to install the application.
BetaLOG must be registered and activated within seven days of
installation. Full operation is available for seven days, but is then
restricted until activation is completed. A registration screen is
displayed at startup until activation is completed. Click Cancel to
proceed directly to the application. Fill in the requested information
and click REGISTER to save it to a text file on disk. Email this file to
Martel as an attachment, or print and fax it, per the contact information
on the support screen. When Martel returns the activation key, enter it
at the bottom of the registration screen and click ACTIVATE to
complete the process.
BetaLOG must be registered and activated separately on each
computer on which it is installed.
4.2 Menus
The control buttons on the Main Display are intended to be the primary
method used to operate the application. The menu items duplicate the
functions of these buttons for those users who are more comfortable
with menu style operation.
The terms of the software license permit the installation of the BetaLOG
application on a single computer. Please contact technical support for
re-installation or to move the application to another computer.
4.2.1 File Menu
The File Menu contains the application exit function:
Exit Exit the Data Log Utility.
4.2.2 Gauge Menu
The Gauge Menu contains the functions required to interact with the
gauge:
Connect Connect to the gauge and retrieve the gauge
description and data logging setup. The
communications port to which the gauge is
connected must be selected on the Main Display
before using this item. See the Connecting to a
Gauge description in the Main Display section 4.3.
Disconnect Disconnect from the gauge. See the Disconnecting
from a Gauge description in the Main Display
section 4.3.
10