Martel Electronics BetaLOG-TI - Manual (Page 9)

BetaLOG TI
User Manual
Revision 1.00, October 22, 2010
Page 9 of 16
shown on the Log Upload Display described in section 4.4. A
progress display shows percent complete and an estimate of the
time remaining in the upload. Data logging must be set to Enabled,
otherwise this function is not available.
Clearing Logged Data
Click the Clear button. After confirmation of the action, all logged
data is cleared from the probe and all data on the display is
refreshed. Data logging must be set to Enabled, otherwise this
function is not available.
Sending Setup Configuration
After making the desired selections, click the Send button. The
configuration is sent to the probe and all data on the display is
refreshed. Data logging must be set to Enabled to change anything
more than the Data Logging mode.
Retrieving Setup Configuration
Click the Retrieve button. The probe description, present capacity,
and present setup are retrieved from the probe and displayed in the
appropriate fields.
Setup Configuration Fields
Data Logging
Disabled Disable data logging in the probe. All data
logging functions are removed from the
probe's SETUP menu sequence.
Enabled Enable data logging in the probe. All data
logging functions are available in the
probe's SETUP menu sequence.
Interval
One of the following sampling intervals:
1, 2, 5, 10, 30, or 60 seconds