Martel Electronics BetaLOG-TI - Manual (Page 4)

BetaLOG TI
User Manual
Revision 1.00, October 22, 2010
Page 4 of 16
1) Start or stop data logging
• Main display: LOG
• Secondary display: FULL if the log memory is full, OFF if not
presently logging data, or ON if presently logging data.
• Press the SETUP key to step to the next menu item.
• If FULL, the ENTER key is ignored.
• If not FULL, press the ENTER key to change to data edit
mode:
- Press the
▼ or ▲ key to toggle between OFF and
START if not presently logging data, or to toggle
between ON and STOP if presently logging data.
- When START is displayed, press the ENTER key
to start data logging and exit data edit mode.
- When STOP is displayed, press the ENTER key to
stop data logging and exit data edit mode.
- When OFF or ON is displayed, press the ENTER
key to exit data edit mode without changing the
data logging operation.
• Press the MAX/MIN key to exit the SETUP menus and return
to the main display.
2) Display number of free log records or percent empty
• Main display: number of free records or percent free
• Secondary display: RECS or PCNT
• Press the ENTER key to toggle between the number of free
log records and percent free.
• Press the SETUP key to step to the next menu item.
• Press the MAX/MIN key to exit the SETUP menus and return
to the main display.
3) Select logging interval
• Main display: interval choice presently selected, one of 1, 2,
5, 10, 30 or 60 seconds.
• Secondary display: SEC
• If presently logging data, the ENTER key is ignored.
• If not presently logging data, press the ENTER key to
change to data edit mode:
- Press the
▼ key to decrease the interval
selection, cycling to 60 after 1.
- Press the
▲ key to increase the interval selection,
cycling to 1 after 60.
- Press the ENTER key to exit data edit mode.
• Press the SETUP key to step to the next menu item.
• Press the MAX/MIN key to exit the SETUP menus and return
to the main display.
4) Send logged data to the RS232 port
• Main display: SEnd