KROHNE OPTITEMP TT 10 C-R EN - Manual (Page 19)

INSTALLATION
3
19
OPTITEMP TT 10 C/R
www.krohne.com 02/2013 - 4000752703 - MA OPTITEMP TT 10 C/R R03 en
3.4 Rail-mount transmitter
1 Hook the upper groove of the transmitter onto the rail.
2 Press the lower part of the transmitter against the rail.
i When you hear a "click" from the snap fastener, the transmitter is fixed onto the rail
(drawing in the centre).
3 To remove the transmitter, use a small screwdriver to push the snap fastener downwards.
4 Carefully move the lower part of the transmitter in the forward direction and then upwards.
Step 2
1 Hook one end of the clamp into the rail as shown above.
2 Push the other end of the the kit down until it snaps onto the rail.
3 Release by pushing the hook, shown in the picture, and at the same time lift the clip out of the rail.
DANGER!
Neither operate this transmitter in potentially explosive areas, nor connect it to a sensor located
in a potentially explosive area! Otherwise the transmitter might cause an explosion that can
result in fatal injuries!
INFORMATION!
The rail-mount transmitter is intended for installation on a rail according to EN 60715 TH35.
Figure 3-2: Installation of the rail-mount version
.book Page 19 Tuesday, February 26, 2013 1:43 PM