KEPCO BOP-HV - Manual (Page 3)

BOP-HV/ 112211
OPERATOR
SAFETY INSTRUCTIONS
Read these safety instructions, as well as the applicable installation and operating instructions contained in
this manual before using the power supply.
Do not touch the output terminals. The high voltage output is dangerous. Electric shock can cause injury or
death.
Do not remove the cover or disassemble the unit. There are no operator serviceable components or
adjustments inside the unit. High voltage components inside the unit can cause serious injury even with
input power disconnected.
Service must be referred to authorized personnel. Using the power supply in a manner not specified by
Kepco. Inc. may impair the protection provided by the power supply. Observe all safety precautions noted
throughout this manual. The following table lists symbols used on the power supply or in this manual where
applicable.
CAUTION
If this power supply is used in OEM equipment, the OEM equipment manufacturer is responsible for
attaching appropriate warning labels on the OEM equipment.
Operating the power supply outside the specified limits for input voltage, temperature, or other environ-
mental conditions noted in this manual can damage the power supply and void the warranty.
Safety Messages
The BOP HV protection circuit is designed to protect the load against unregulated high voltages. Upon
sensing a high temperature signal, the protection circuit shuts down the output stage before the overtem-
perature can destroy the transistors. In addition to that, the protection circuit shuts down the output stage
when there is a lapse of AC input power for more than 8 ms. This feature is provided so as to avoid an
uncontrolled output signal during the shut OFF of the power supply.
SAFETY SYMBOLS
SYMBOL Meaning
WARNING: RISK OF ELECTRIC SHOCK.
INDICATES THE POSSIBILITY OF BODILY INJURY OR DEATH.
CAUTION: REFER TO REFERENCED PROCEDURE.
INDICATES THE POSSIBILITY OF EQUIPMENT DAMAGE.
WARNING
!