In-Situ Controller Radio & Board Replacement Kit - Manual (Page 3)

3
8. Click the following labels one at a time and enter the proper network settings: HP,
DT, MK, and SM. See page 2.
If you do not know the network settings you might be able to
determine them from a known-good radio on the network. See
page 4.
9. Click the Write button to write the settings to the new radio.
10. Click the Terminal tab to change the Modem VID.
11. All radios in a network must be set with the same VID.
12. Type +++ to put the radio into programming mode for 20 seconds.
13. Type atid followed by the 4-digit ID number (e.g. atid3456) and click Enter.