In-Situ Aquaculture Aerator Controller Manual - Manual (Page 9)

Mounting the Controller 9
Chapter 3 Mounting the Controller
Danger
Only properly trained and qualified personnel should
install the Aqua Con TROLL instrument described in this
manual. This instrument should be installed for use in non-
hazardous locations only.
Danger
L'installation de l'appareil "Aqua Con TROLL" décrite dans
le guide d'utilisateur doit impérativement être réalisée
par des personnes qualifiées. L'installation de cet appareil
est seulement prescrite pour des emplacements sans
risques.
3.1 MOUNTING REQUIREMENTS
• For safety and ease of mounting, mount the enclosure before connecting
any wiring.
• When mounting the controller, make sure that the mounting hardware and
mounting surface are sufficiently strong to support at least 23 pounds
(10.4 kg).
• Mount the enclosure so that the antenna sits on top of the enclosure. The
enclosure will not be sufficiently water-tight if mounted with the antenna
pointing toward the ground and the cable grips pointing upward.
3.2 MOUNTING THE ENCLOSURE
Mounting strip dimensions are shown in Figure 2. Fasten them to the back of
the enclosure and mount to a secure wall using the appropriate hardware.