GW Instek PSS-Series User Manual - Manual (Page 5)

PSS-3203/2005 PROGRAMMABLE POWER SUPPLY
USER MANUAL
⎯ 4 ⎯
Interface RS232 (GPIB interface option)
Power Source AC100V, 120V, 220V±10%, 230V +10%/-6% 50/60Hz
Power
Consumption PSS-2005: 215W
PSS-3203: 190W
Dimensions
110(W)×140(H)×320(D) mm. Mechanical
Spec.
Weights 4.8 kg
Operation
Environmental Indoor use
Altitude up to 2000 m
Ambient temperature :
To satisfy specifications : 10℃ to 35℃ ( 50
° F to 95°F )
Maximum operating ranges: 0℃ to 40℃( 32 °F to 104°F )
Relative humidity: 85% RH(max.) non condensing
Installation Category: II
Pollution degree: 2
Storage
Temperature &
Humidity
-10 ° to 70℃, 70%RH (maximum)
Accessories
Power cord….............……….. × 1
Instruction manual……………..× 1
Programmer manual................. × 1
Test Lead……….………………× 1
PSS-3203/2005 PROGRAMMABLE POWER SUPPLY
USER MANUAL
⎯ 5 ⎯
3.PRECAUTIONS BEFORE OPERATION
3-1.Unpacking the Instrument
The product has been fully inspected and tested before shipping from the
factory. Upon receiving the instrument, please unpack and inspect it to
check if there is any damage caused during transportation. If any sign of
damage is found, notify the bearer and/or the dealer immediately.
3-2.Checking the Line Voltage
The product can be applied by any kind of line voltages shown in the table
below. Before connecting the power plug to an AC line outlet, make sure
the voltage selector of the rear panel is set to the correct position
corresponding to the line voltage. It might be damaged the instrument by
connecting to the wrong AC line voltage.
WARNING. To avoid electrical shock the power cord
protective grounding conductor must be connected to
ground.
AVERISS: Pour éviter les chocs électriques, le fil de terre
du cordon secteur doit impérativement être relié à la
terre.
When line voltages are changed, replace the required fuses shown as below:
Model
Line
voltage
Range Fuse
Line
voltage
Range Fuse
PSS-3203
PSS-2005
100V
120V 90-110V
108-132V
T3A
250V
220V
230V 198-242V
216-250V T1.6A
250V