beautypg.com

Operation, Gds-3000 set up, Peration – GW Instek GDS-3000 Series GUG-001, GPIB to USB adapter User Manual User Manual

Page 9: Set up

background image

OPERATION

O

PERATION

GDS-3000 Set Up

Procedure

1. Connect a GPIB cable from a GPIB

controller to the GPIB port on the
adapter.

2. Connect the USB cable from the

rear panel device port (type B
receptacle) on the oscilloscope to
the USB port (type A receptacle)
on the GPIB to USB adapter.

→

3. The Ready Indicator should be lit after the USB

cable is connected.

Configure GPIB

1. Press the Utility key on the GDS-

3000 front panel.

2. Press I/O from the bottom menu.

9

See also other documents in the category GW Instek Equipment: