GW Instek GLA-1000 Series Quick start guide - Manual (Page 10)

Tool bar
Standard Group
Create new project file.
Open a project file.
Save the project file.
Print out the display.
Trigger Group
Configure sampling rate.
Configure signal bus.
Setup enable function.
Setup bus trigger properties.
Setup signal trigger properties.
Setup general trigger properties.
Enable/disable data compression.
Run/Stop Group
Single run.
Continuous run.
Stop running
Sampling group Select sampling
memory size.
Select sampling
frequency.
Trigger content
set group Set trigger position.
Set trigger page.
Set trigger count.
Display mode
group
Horizontal unit in address.
Horizontal unit in time.
Horizontal unit in frequency.