Iii - 3.1.4. configuration example, Iii - 3.1.4, Configuration example – Fire-Lite IPDACT-2UD Technical Reference User Manual
Page 31

IPDACT-UD - Configuration
III-28
Doc.DM385-I
Rev. 2.0
IPDACT-UD access gateway
02
IPDACT-UD account number
11
Main VisorAlarm IP address
12
Backup VisorAlarm IP Address
21
UDP Port
13
b) If you have a DHCP server
Type of register
Register
IPDACT-UD account number
11
Main VisorAlarm IP address
12
Backup VisorAlarm IP Address
21
UDP Port
13
After configuring these parameters and restarting the device, the installer
must re-access the telephonic console as previously described and access
register 04. Here the installer password configured in the VisorALARM must
be configured. If the IPDACT-UD has IP connectivity with the VisorALARM
and the password is correct, the IPDACT-UD will receive the configuration
defined in the profile configured in the VisorALARM.
Through this mechanism, the installed IPDACT-UD is registered in the Teldat
VisorALARM which from this point begins to monitor the former and the
IPDACT-UD receives the necessary configuration in order to exchange
information with the Teldat VisorALARM.
If the whole process has gone smoothly, the IPDACT-UD will begin to
exchange monitoring messages with the VisorALARM and from this point
onwards the IPDACT-UD telephone relays activate (the line status LED lights
up).
III - 3.1.4.
Configuration Example
In cases of configuring the IPDACT-UD with the following data:
IP address: 192.168.1.100, mask 255.255.255.0
Access GW: 192.168.1.20
IPDACT-UD account number: 1234
Main VisorAlarm IP: 10.24.6.1
Backup VisorAlarm IP: 80.6.189.123
UDP port: 3000
The registers and the data are, in cases where the testing digit is disabled
(through register 49):