Fire-Lite IPDACT-2UD Technical Reference - Manual (Page 25)

IPDACT-UD - Configuration
III-22
Doc.DM385-I
Rev. 2.0
SURGAR MLR2D 1
RADIONICS 6500 1
ADEMCO 685 1
The IPDACT-UD permits you to code the LINE-ID field with up to 4 digits to
anticipate a new alarm-receiver with up to 4 digits for LINE-ID.
How the LINE-ID is coded according to the type of alarm-receiver is shown by
the following example: if the account number is A2345678, the LINE-ID is
coded as depicted in the following table:
Emulated receiver LINE-ID digits
SUR-GAR MLR200 A23
SURGAR MLR2D A
RADIONICS 6500 A
ADEMCO 685 A
With the aim of consistency in the information shown by the Automation
Software, it is necessary that the 4 right-hand digits of the IPDACT-UD
account number are the same as the panel’s 4 digit account number.
Teldat VisorALARM IP address
IP address for the IP VisorALARM receiver which receives both the
monitoring traffic as well as the traffic corresponding to the alarms generated
by the control panel.
The register is made up of 4 fields corresponding to the 4 numbers in the IP
address; this admits values between 0 and 255. Each number has a
verification digit. This contains the following value by default:
000 000 000 000
UDP Port
UDP port used to send and receive monitoring, alarms and remote
configuration information. This port must coincide with that programmed in
the IP VisorALARM receiver.
The register is composed of one 5-digit field which admits values within the
range of 00000 to 65535. The field contains a verification digit of the
configured number. Default value is 00080.
A 0 value is not permitted.
IPDACT-UD message encryption key
This key is used to encrypt the messages sent to the Teldat VisorALARM.
This must be entered twice in order to validate it.