Fire-Lite IPDACT Configurator Quick Guide - Manual (Page 4)

STEP 4
If the LAN (Local Area Network) where the IPDACT is going to be connected has a
DHCP server you must fill in the next parameters in the “Quick Install” screen (see
Fig. 5):
• Check the Enable DHCP client box: This configures the device to use
DHCP to get an IP address and gateway from a DHCP server in the LAN.
•
Account Number
: This is the IPDACT account number that identifies the
subscriber and can be up to 8 digits long.
•
Main VisorALARM IP address
and Backup VisorALARM IP address: IP
addresses for the main and backup VisorALARM receivers.
•
UDP Port
: the receivers’ UDP port where the IPDACT sends alarms and
supervision messages.
•
Auto-register password
: This is the registration password that the IPDACT
will use to connect to the VisorALARM and to obtain its configuration
settings.
Fig. 5
Go to STEP 6.
Dm378-Iv3 4