Astro Design PORTABLE SIGNAL GENERATOR PROGRAMMING SOFTWARE SP-8848 User Manual

Page 20

Click [Apply] so that the configuration settings will take effect and the actual changes will be made. When this button is

clicked on the [Interface] page, the commands are sent to the VG unit and the settings are changed only if

communication is enabled. If communication is disabled, only the configuration data managed by the PC will be

updated.

Bear in mind that even when the settings have been changed, these changes will
be lost if the software is closed without clicking the [Apply] button first.

Click [Close] to close the configuration setting program.

Interface page

The parameters for communication with the VG unit can be set on this page.

Select the communication
method here.

Selecting the communication method

Enable

This setting enables communication and allows "VG (Serial)," "VG (LAN)" or
"PC" to be set. The setting items differ depending on the VG model.

VG (Serial)

This setting selects the RS-232C port to be used as the communication method.

VG (LAN)

This setting selects the LAN to be used as the communication method.

This setting selects access to the memory card, which is connected directly to the
PC and on which is written the data, as the communication method.