Detcon CXT-N7 - Manual (Page 9)

Model X40
Model X40 Instruction Manual Rev. 0.0 Page 3 of 23
2.
Installation
2.1 NEMA 4 units
The CXT-N4X controller is housed in a NEMA 4X water/corrosion proof stainless steel enclosure for
indoor/outdoor use. Securely mount the Model CXT-N4X enclosure per the mounting dimensions
provided in Figure 4 Power is provided by a battery pack. that can be charged by an external battery
charger. No other outside connections or wiring is utilized, as the unit is self contained.
10"
14
12.00"
13.75"
12.75"
3.72"
4.2"
Ø0.27"
Mounting
Bracket
11.0"
Figure 4 CXT-N4X Controller Mounting and Dimensional View
The CXT-N4X controller is battery powered, and thus is self sustaining. An external Battery Charger is
included to charge the internal batteries when needed. The battery charger connects to a cannon plug
provided on the side of the unit. The battery charger is AC powered, and a 100~240VAC 50~60Hz power
source is required for operation.
NOTE: The battery charger is meant to charge the unit’s batteries, and should not be used to
operate the unit for any length of time.
When the unit is turned on by the On/Off switch mounted on the left side of the unit, the unit will begin
normal operation after a brief power-up diagnostic sequence.