Detcon PI-600 User Manual
Page 29
and push down on the end with the pins. Make sure the cell assembly is f lush with the lamp window.
4) Place the spacer around the assembly.
5) Place the f ilter media over the Cell Assembly centered on the top of the sensor. Make sure the f ilters are installed in
the correct order. Filter Media #2 f irst, then Filter Media #1 on top, with the shiny side up.
6) Align the Cap Key with the notch on the housing. Starting at the side opposite the notch, press down until the
Filter Cap snaps on to the housing. If the Cap Key is incorrectly aligned there will be a noticable buldge on the side of
the Cap.
PI-600 Toxic Gas Sensors PG.29
See also other documents in the category Detcon Sensors:
- TP-700 (48 pages)
- TP-700 SIL 2 Safety Manual (6 pages)
- FP-700 (50 pages)
- FP-700 SIL 2 Safety Manual (6 pages)
- IR-700 (50 pages)
- IR-700 SIL 2 Safety Manual (6 pages)
- DM-700 (58 pages)
- DM-700 SIL 2 Safety Manual (6 pages)
- PI-700 (64 pages)
- PI-700 0-500ppb (59 pages)
- DM-634 (21 pages)
- DM-600IS (41 pages)
- IR-640 (24 pages)
- IR-622 (24 pages)
- FP-624D-HT (48 pages)
- FP-524HT (22 pages)
- FP-624D (46 pages)
- FP-624C (26 pages)
- TP-624D (44 pages)
- TP-624C (25 pages)
- TP-524D-HRT (52 pages)
- TP-524D (40 pages)
- TP-524C (20 pages)
- FP-524D-HRT (52 pages)
- FP-524D Quick Start Guide (2 pages)
- FP-524D INSTRUCTION MANUAL (43 pages)
- FP-524C (21 pages)
- PI-500 (31 pages)
- TP-424C (15 pages)
- DM-200 (50 pages)
- DM-100 (44 pages)
- FP-100 (34 pages)
- SG1 (16 pages)
- DM-534C (22 pages)
- IR-540 (19 pages)
- IR-522 (19 pages)
- DM-434B (11 pages)
- DM-400IS (22 pages)
- FP-424C (15 pages)