Detcon IR-700 - Manual (Page 7)

Model IR-700
IR-700 Instruction Manual Rev. 3.1 Page 3 of 40
1.2 Sensor Electronics Design
1.2.1 Intelligent Transmitter Module
The Intelligent Transmitter Module (ITM) is a fully encapsulated microprocessor-based package that accepts a
plug-in field replaceable combustible gas sensor and for IR-700 CO
2
sensors, a plug-in replaceable CO
2
sensor. Circuit functions include extensive I/O circuit protection, sensor pre-amplifier, on-board power
supplies, microprocessor, LED display, magnetic programming switches, a linear 4-20mA DC output, and a
Modbus™ RS-485 output. Magnetic program switches located on either side of the LED Display are activated
via a hand-held magnetic programming tool, thus allowing non-intrusive operator interface with the ITM.
Calibration can be accomplished without declassifying the area. Electrical classifications are Class I, Division
1, Groups B C D and Class I, Zone 1, Group IIB+H
2
.
Figure 4 ITM Circuit Functional Block Diagram
Program Switch #1
LED Display
Program Switch #2
MODEL
IR-700
detcon inc.
LEL Sensor
Splash Guard Adapter
Locking Set-Screw
Figure 5 Sensor Assembly Front View
1.3 Modular Mechanical Design
The Model IR-700 Sensor Assembly is completely modular and made up of four parts (See Error! Reference
source not found. for Assembly Breakaway):
1) IR-700 Intelligent Transmitter Module (ITM)
2) Field Replaceable Plug-in Infra-Red Gas Sensor
I/O
Circuit
Protection
RS-485
4-20mA
Display
Micro-
Processor
Pre-Amp Analog 4-20mA Out
Modbus™ RS-485 Output
Power In
Power Supply
Plug-In
Sensor
Element